The heater's power supply must use a qualified three-hole socket with a ground wire, otherwise there will be a risk of leakage. Because the heater has a large power, it should not be used with high-power electrical appliances at the same time, otherwise the heater will be easily damaged. In addition, the socket cannot be located directly above the heater to prevent the heat from rising and burning the power supply. When there is no one in the room, be sure to unplug the heater. To use the heater, you must use a three-hole socket with a ground wire in accordance with the specifications of the standard.
Never change to a two-hole socket without a ground wire, because it is easy to generate static electricity, and sometimes it will feel like an electric hand, which is more dangerous. In addition, the socket should not be located directly above the heater to prevent the heat from rising and burning the power supply. Third, if there are electrical appliances that are prone to sudden changes in current and are more frequent, such as electric welders, percussion drills, etc., used at the same time as the heater, it is easier to damage the heater, and attention should be paid to it. It is best to use an overcurrent protection device. Power strip or use a stabilized power supply. No items can be covered on the heater. The surface temperature of the heater is relatively high. Once the object is covered, the heat cannot be dissipated in time, which will cause the machine to burn and ignite other objects.
In the installation and placement position, the heater should be placed in a place that is not easy to touch, away from combustible materials, and the back should be about 20 cm away from the wall. If you place the electric heater in the bathroom for heating, you must be especially careful to prevent the adverse consequences caused by the power source being exposed to water. It is best to install the power socket outside the bathroom, and the heater wire should be protected by insulating rubber, and to ensure that the connection with the body avoids contact with water. Some people like to stay close to the heater to keep warm, and even put their hands and feet on the heat sink. This is very easy to burn. Some people blow the heater directly at the body, although it is warm for a while, but if it does so for a long time, it will burn the skin.
Therefore, do not use the heater too close to the heater, especially do not let the heater's air outlet directly close to a certain part of the body to heat. In the dry winter, the skin will gradually lose its surface oil and have poor moisturizing ability. If the heater is used indoors, the environment will be even drier, resulting in dehydration, chapped and itchy skin. Therefore, when using a heater at home, you should find ways to increase the indoor humidity, such as raising some hydroponic plants in the house, putting a few pots of clean water, mopping the floor frequently, and using a humidifier.