1. Tips on electric heaters Use electric heaters in winter to warm the room. In order to keep the indoor temperature suitable for human body temperature, the general temperature should be 17～19℃, children’s room 18～20℃, bedroom 14～16℃ is better. Nowadays, most electric heaters have fixed temperature control. When the heating room reaches the proper temperature, it stops heating, which can reduce unnecessary power waste. There are many types of household electric heaters, please choose the appropriate model according to the purpose when purchasing. 2. Daily maintenance and heat dissipation of the electric heater: In order to make the electric heater play a better heating effect, and make the body work normally, and extend its service life, try to place the electric heater in a position that is conducive to air circulation and heat dissipation. Cleaning: It is best to use a soft cloth and household detergent or soapy water for scrubbing. Do not use gasoline, toluene, etc. to release solvents, so as to avoid damage to the shell, affect the appearance or rust. 1. Correct use of thermostats Electric oil heaters do not have thermostats, so that the surface temperature of the heater shell can be adjusted at will (below 110°C). During normal operation, the thermostat should not always be set to the highest level, otherwise the thermostat will not be easy to operate when the working temperature of the heater surface is close to 110°C. Long-term high temperature operation will easily cause internal components to burn, age, or damage the protection. Therefore, when using the electric oil heater for the first time, set the thermostat in an appropriate position. When adjusting, first turn the thermostat knob clockwise to the maximum position, turn on the two power switches, the whole machine is in the maximum output state, heat up for about 5 minutes, lightly tap the upper surface of the shell with the back of your hand. Feeling that the temperature is appropriate, turn the knob counterclockwise gently until there is a crisp sound of the contact bounce, and the power indicator on the power switch goes out, and then gently rotate it clockwise to a small angle without touching it. Click to close.